Kong DUCK Black-ITA Green ultra-compact emergency rescue clamp lock for ropes 8-13 mm
Product Code 88800NG00KK
Innovative ultra-compact emergency rope clamp.
Designed for single ropes with a diameter between 8 and 13mm, Duck also works on slings mod. Yaku Vario and Aro Sling Tubular.
Very small in size, it is easy to insert even with one hand.
In addition, the large attachment hole also allows the rotation of the locking carabiners.
Duck was born as an emergency ascender useful in recovery maneuvers, self-rescue, progression in
preserves and as a regulator for lanyards or webbing.
Available set consisting of Duck + OVAL ALU screw connector (# 888SET001KK - not yet)
High quality product, completely made in Italy!
Product in the Personal Protective Equipment category
Category III 888.000 "DUCK" is:
-a rope clamp attached to a rope that will tighten under load in one direction and move freely in the opposite direction;
-part of a system preventing/protecting against impact caused by a fall from a height;
-certified in accordance with EN567:2013 and UIAA 126:2018 standards.
Instructions for use:
Fig. 1 – Fixing – The cam (B) is always in the free direction:
-open the bracket (A);
-insert the rope/tape between the cam (B) and the drum (C);
-close the bracket (A) and lock it on the drum (C);
-fix the connector so that it passes through the drum (C).
In a safe position and before use, check that it moves freely in the desired direction and locks in the opposite direction.
Fig. 2 – Unlocking – To unlock this device, pull the cam (B) or its auxiliary rope after unloading.
Fig. 3 – Enemy knots – Never press this device against a knot, it can be very difficult to release.
Fig. 4 – Lifting – This device can be used to lift loads (WLL 400 kg).
Fig. 5 – Adjuster – This device can be used as a length adjuster for lines attached to the harness.
Fig. 6 – Examples of improper and unsafe use.
Compliance
– This device has been designed for use with:
- connectors in accordance with EN362 and/or EN12275;
- ropes with a diameter of 8 mm to 13 mm, certified in accordance with EN564, EN892 or EN1891;
- KONG “YAKU” and KONG “ARO TUBULAR” ropes.
Inspections before and after use
Before and after use, make sure that the device is in good working order and operates correctly, in particular check that:
- it is suitable for the intended use;
- it has not been mechanically deformed;
- it shows no signs of cracks or wear;
- the support (A) locks onto the drum (C);
- the rivets on the plate (D) are intact and without cutting edges;
- the cam (B) closes completely automatically and correctly;
- the markings are still legible.
Before use and in a completely safe position
Check each time that the device is held correctly by loading it with its own weight.
Important:
- the device is not suitable for use on steel ropes;
- the connector must be equipped with a gate lock;
- the device works properly on dry and clean ropes;
- never use only one locking device when moving on a free rope;
- the device may not work properly when attached to insufficiently tensioned ropes;
- applications as a lifting or regulating device are not covered by the PPER Regulation (EU) 2016/425;
- special conditions (e.g. heat, cold, humidity, oil, dust, mud, snow) can impede or affect the operation of this device.
Warning:
- Always attach the connector through the drum hole (C);
- This device is not a fall arrest device according to EN363;
- When used for lifting, the rope must always run on the drum (C);
- The potential fall height must always be less than 0.5 m unless the user is equipped with appropriate certified devices (e.g. energy absorbers according to EN355) that protect against the dynamic forces acting on the user during fall arrest.
- Always hold the device:
- Below the rope/strap anchor point;
- Above the harness attachment point.
Usage: without restrictions while maintaining technical control of the product and its operational efficiency.
Warranty: 2 years
